NEW RACING CLUTCHES! CLICK HERE TO FIND OUT MORE!

  • SPROCKET CLUTCH FOR VESPA

  • ULTRA LIGHTWEIGHT | ALUMINIUM | T10 SPROCKETS
  • DREMEL EXTENSION TOOL WITH SANDING DRUMS

  • IDEAL FOR TUNING | PORT MATCHING | TRANSFERS | BOOSTERS
  • POLINI H2O 41MM GASKETS

  • LIMITED EDITION!

SPROCKET CLUTCH FOR VESPA

ULTRA LIGHTWEIGHT | ALUMINIUM | T10 SPROCKETS BUY NOW! FROM €169.95

DREMEL EXTENSION TOOL WITH SANDING DRUMS

IDEAL FOR TUNING | PORT MATCHING | TRANSFERS | BOOSTERS BUY NOW! FROM €13.95

POLINI H2O 41MM GASKETS

LIMITED EDITION! BUY NOW!
  • GAS SPRINGS FOR VESPA CIAO FORKS

  • NOW AVAILABLE IN BLACK | STAINLESS STEEL | REINFORCED
  • PICK YOUR FUEL CAP!

  • EXCLUSIVE DESIGNS | ALUMINIUM | FUEL RESISTANT
  • MALOSSI KICKSTART HOUSING

  • REED VALVE & MP-ONE COMPATIBLE | GET KICKING NOW! | LIMITED AVAILABILITY

GAS SPRINGS FOR VESPA CIAO FORKS

NOW AVAILABLE IN BLACK | STAINLESS STEEL | REINFORCED BUY NOW! STARTING AT €84.95

PICK YOUR FUEL CAP!

EXCLUSIVE DESIGNS | ALUMINIUM | FUEL RESISTANT BUY NOW!

MALOSSI KICKSTART HOUSING

REED VALVE & MP-ONE COMPATIBLE | GET KICKING NOW! | LIMITED AVAILABILITY BUY NOW!

what our customers say about moparts racing

Always happy to visit the MOPARTS RACING website and find new products! Keep up the good work!

Björn Gustavson, Sweden

I've been running the Front Wheel Bearings for three years now and couldn't be happier. Definitely a must have!

Peter Frankendorf, Switzerland

Using both the MOPARTS RACING Malossi and Polini manifolds on my engines. Finally a solution to run bigger carbs!

Jahn Müller, Germany

The Front Wheel Bearings are a must have! Bought one for my Gilera Citta. Very satisfied!

Jochem d. V., The Netherlands

Bought the MOPARTS RACING Clutch - what an awesome piece of engineering! Crazy, just crazy.

Benjamin N., USA

Een wereld van verschil tijdens het rijden! De Ciao Fork Busjes zijn een echte aanvulling voor de Ciao rijder!

Rick G. / Solex 105, The Netherlands

Since years without any problem!
I replaced the original bearings years ago with the Front Wheel Bearings (5-Star wheels) and I am still happy with it. No problems, less friction than original. Must have!

Henning M., Germany

Na lang zoeken eindelijk iets gevonden dat werkt! Heb het DREMEL EXTENSIONS TOOL getest en is zeer handig voor het bewerken van de uitlaatpoort. Door de verlengde schacht kun je overal makkelijk bij komen.

Davy N., The Netherlands

I have the old version of the Bearing Plate, with the square sides on it. I've been using this plate for about 2 years now. Holds up good and the finish stays nice! Recently got the Rear Wheel Nuts and those look good in combination with this plate.

Marten S., The Netherlands

MOPARTS RACING BLOG